Difference between revisions of "DPSI BUS HUB"

From Hacker Motor Wiki
Jump to: navigation, search
Line 8: Line 8:
  
 
==Connections and wiring==
 
==Connections and wiring==
===Flächen-Verkabelung===
+
===Wing wiring===
Der Anschluss zu den Flächen erfolgt über 30cm lange Silikonkabel mit verriegelbaren Flächensteckern. Bei dünnen Flächenprofilen können in den Tragflächen die '''Bus-Flächenstecker für 2 bzw. 3 Servos''' eingesetzt werden.  
+
The connection to the wings is made with xxin long silicon cables with latching wing plugs. For thin wing profiles inside the wings the '''Bus wing plugs for 2 or 3 servos''' can be used.
  
 
Alternativ können bei dickeren Flächenprofilen auch die '''Bus-Flächenkabel mit Stecker''' zum Einsatz kommen. Der Servoanschluss erfolgt hierbei über [[Servo SinglePort|Servo SinglePorts]].
 
Alternativ können bei dickeren Flächenprofilen auch die '''Bus-Flächenkabel mit Stecker''' zum Einsatz kommen. Der Servoanschluss erfolgt hierbei über [[Servo SinglePort|Servo SinglePorts]].

Revision as of 10:33, 22 October 2015

Product description

DPSI BUS HUB

The DPSI BUS HUB is a digital bus distribution module which can feed through common sum signals. It is equipped with the connectors and can be extended if desired. The DPSI BUS HUB ensures connections of approx. ten bus servos without soldering. The servos can be connected with the HUB-2 and HUB-3 plug system or with latching Bus wing plugs and sockets to the DPSI BUS HUB.

Connections and wiring

Wing wiring

The connection to the wings is made with xxin long silicon cables with latching wing plugs. For thin wing profiles inside the wings the Bus wing plugs for 2 or 3 servos can be used.

Alternativ können bei dickeren Flächenprofilen auch die Bus-Flächenkabel mit Stecker zum Einsatz kommen. Der Servoanschluss erfolgt hierbei über Servo SinglePorts.

Rumpf-Verkabelung

Servos im hinteren Rumpfteil werden an ein 120cm langes integrierte HUB-2 Kabel angeschlossen, weitere Servos können über zusätzliche HUB-2 oder HUB-3-Kabel angeschlossen werden.

Connections diagram

Bus connectors DPSI BUS HUB
Tabelle 1: Bus connectors DPSI BUS HUB
Connector Description
1 Bus connection cable with sockets to connect wing plugs
2 Hub2 bus cable to connect bus servos

Specifications

Table 1: Specifications DPSI BUS HUB
Input voltage 6V - 8.4V (5 NiMH or 2S Li++)
Output voltage (regulated for RX output) 5.9V
Ampacity (RX output) Permanent 2A, Peak 10A @ 2S LiPo battery
Output voltage (unregulated for servos) Identical to the input voltage
Ampacity (unregulated output) Permanent 8A, Peak 16A
Power-on control LED
Quiescent current approx. 3.5mA @ 7.4V
Max. amount servos 10
Dimensions 50mm x 39mm x 14mm
Weight approx. 86 Gramm