DPSI Micro MPS
Compact and failsafe magnetic switch e. g. for the receiver system. Contactless switching with an external magnet through the aircraft fuselage wall. From the outside only the status LED is visible.
DPSI Micro Systems can be switched on and off contactless with an external magnet through the model's fuselage wall or with the transmitter, so they can be fixed at the fuselage inner sidewall. The switching on and off process with the magnet works up to a distance of about 8mm (0.3in) from the DPSI Micro's surface through the fuselage wall. To see the LED from the outside a small hole with 5mm (0.2in) diameter can be drilled in the fuselage wall.
Sticking on the DPSI Micro system
The DPSI Micro can be sticked on with silicone directly on the fuselage's inner sidewall.
Screwing on the DPSI Micro system
The DPSI Micro can be screwed from the outside to the fuselage wall. The required holes can be drilled using the included drilling template.
Both screws can be feed through the drilling holes from the outside. The screws are positioning helps for the self-adhesive foam rubber, which can be used as vibration protection. It is pushed over the screws from inside and glued to the fuselage's sidewall.
The DPSI Micro can be mounted with two included M3 screws. The screwing collars enlarge the area of support and inhibit in this way damage to the fuselage.
Switching on and off
For switching on the DPSI Micro MPS magnetic switch the included magnet must be placed over the switching on position (ON) for approx. 1 second. For switching off the DPSI Micro DualBat the magnet must be placed over the switching off position (OFF) for approx. 2 seconds. The switching on and off process works through the fuselage wall.
|Dual power supply||No|
|Servo current distribution||No|
|Servo signal distribution||No|