DPSI V-Match
Contents
Product description
The DPSI V-Match is a servo v-cable which allows the operating of two servos on one receiver or DPSI channel. The servo connected to the "SLAVE" channel can be programmed via the DPSI V-Match.
Functions
Changing of servo direction, servo middle and servo end position
The DPSI V-Match allows changing of servo direction as well as calibration of servo center and end positions of the servo connected to the "SLAVE" port. The programmed values are based on the looped in servo signale which is processed by the "MASTER" servo without being modified.
Failsafe function
Both servos ("MASTER" and "SLAVE") remain at their current position (HOLD) when encountering an erroneous or missing receiver signal until a valid signal is again delivered by the receiver. A flashing red LED (at the PCB's side) indicates this state and stays active (i. e. flashes) until power is turned off.
Pulse amplifier & HF suppression
Besides pulse amplifiers, which recognize and amplify even weak servo signals, high effective noise filters are built into the DPSI V-Match. Therefore, ferrite cores or other noise suppression measures can be omitted.
Delivery contents
Text
Mounting
Text
Programming
Changing of servo direction
Text
Calibrating servo center
Text
Calibrating servo end positions
Text
Deleting all programming
Text
Programming of several servos
Text
Limits of tuning range
Text
Specifications
Technische Daten
| Voltage range | 4V ... 8.4V |
| Current consumption | approx. 4.7mA |
| Servo signal level input | Low level: 0V ... 0.8V High level: 2.0V ... 8.4V |
| Servo signal level output | Supplying > 5.1V: approx. 5.0V Supplying < 5.1V: supply voltage -0.1V |
| Max. current | 8A permanent, 20A peak |
| Allowed center position | +/-100% (1.10ms ... 1.90ms) |
| Allowed end positions* | +/-200% (0.70ms ... 2.30ms) |
| Allowed signal cycle time | min. 6.9ms, max. 34.868ms |
| Resolution (steps) | 3200 |
| CE test | according to2004/108/EC |
| Temperature range | -20°C ... +85°C |
| HF noise suppression | -30dB attenuation @ 35MHz |
| Dimensions | approx. 50mm x 8,4mm x 7,2mm |
| Weight | approx. 4.5g |
